Users cannot configure the PRI-group and "% No DSP resources available to configure pri-group on con...
Users cannot configure the PRI-group and "% No DSP resources available to configure pri-group on controller E1 or the No DSP resources available to configure pri-group on controller T1" error message is received
Cisco 2800 Series Integrated Services Routers support the same five Packet Voice/Data Modules (PVDMs) that are supported on the IP Communications High-Density Digital Voice Network Module (NM-HDV2). The supported PVDMs are:
Note: The number in the suffix (for example, the 8 in PVDM2-8) is a measure of the PVDM voice-processing capacity and indicates the number of G.711 channels that the PVDM supports.
Cisco 2821 and 2851 Series routers have three PVDM slots. Based on the number of Digital Signal Processors (DSPs) available on the router, different voice cards and modules can be configured on the router.
To resolve this issue, calculate the number of DSPs consumed by the current configuration (T1, Foreign Exchange Office (FXO), Foreign Exchange Service (FXS)) on the Cisco 2800 Series router with the DSP Calculator. A fully loaded T1 consumes 24 channels. One channel each is consumed for FXO and FXS configurations. Determine the number of DSPs free to be configured for a new T1 connection.
If the existing configuration consumes the available DSPs, either delete the unused existing configuration or purchase more DSPs for the 2800 Series router (from the list of supported PVDMs).
Local Zone: This is a collection of all devices that are registered with Cisco Expressway. The local zone is divided to subzones. These subzones include the automatically crated default subzone and up to 1000 manually configured subzones. In additio...
Hi We are getting an invalid ANI number on the report Abandoned Call Detail Activity Report. Instead of showing the original calling number is showing the Cisco Unity Connection port DN Call Flow: PSTN CLID(1-555-555...
Ok using the Cisco Room Kit Mini as a VTC device, yet out of the box the "WebcamOnlyMode" is turned "On" by default. So when I power up the Touch 10, I do not get the startup wizard. I get trying "Connect to room device". with the spinning don...
Dear All,I have the following setup: CUCM 11.5(1)SU10 IMP 11.5(1)SU10 both clustered,MRA based on two Exp-C and Exp-E clusters of 14.0.2Everything worked find for long time unlit users devices started receiving Jabber 14 update.The only problem I ha...
Is this command still supported in 9.15: Audio Microphones Mute EnabledDefine the microphone mute behavior on the device.Requires user role: ADMIN, INTEGRATORDefault value: TrueValue space: True/InCallOnlyIt shows in the Configuration pages, but sett...