VG248 ports do not auto register to CallManager

[TCC_2]

Core Issue

VG248 ports do not auto register to Cisco CallManager. If you try to register port 0 to represent port 1 on the VG248, the ports do not register successfully.

Resolution

Port 0 is used to integrate smdi-based voice mail systems.

To get ports to register, perform these steps:

1. Delete port 0 from Cisco CallManager.
   
   
2. Configure port 1 in Cisco CallManager.
   
   
3. Disable or enable the correct ports on the VG248.
   

For more information, refer to these documents:

• Configuring VG248 ports using CallManager
  
  
• Troubleshooting the VG248