The site-to-site WAN connection is 64k. Communication to printers and other servers occurs over this link, in addition to the up to six phone users who generally do not all use the phone at the same time. Voice connections are working but are of poor quality.Low Latency Queueing (LLQ) is properly configured to protect voice from data. The current equipment is running G.729 voice codec. There is no compression for the WAN connection.
Without Compressed Real Time Protocol (cRTP), the G729 codec requires about 24Kbps per call at a full rate. In this example, once a third concurrent call was established across the 64Kbps link, the voice quality would suffer and become either choppy, synthetic, or both.
To resolve the issue, perform these steps:
Change the codec on both sides for this connection to be G.723.
Implement Multilink Point-to-Point Protocol (MLPPP) and cRTP for the WAN.
As a result, up to seven calls can be carried out simultaneously. Also, existing LLQ ensures that voice is protected from large data transfers.
Implementing cRTP and G.723.1 reduces the bandwidth requirement per call to the order of 8Kbps. Therefore, this theoretically supports about seven calls across the 64Kbps link.
Although voice is protected from data, the data is not necessarily protected from voice. In addition, should more telephones be added to the network, some form of Connection Admission Control (CAC) is recommended.
The voice quality of a G.723 call may be lower than for a G.729 call. Conferencing may not be possible with lower bit rate codecs. Certain codecs may not be supported on certain hardware platforms.
I have a supervisor that is unable to see herself in UCCX Administration to assign herself skills. She also can not see another resource that is assigned a supervisor role to assign him skills. She asked the Primary Supervisor of the Team with the CSQ to ...
I am using Cisco Unified CM AdministrationSystem version: 220.127.116.1100-11Cisco Unity Connection AdministrationVersion 18.104.22.16800-11I want to set up the helpdesk phone to go to a recorded message that instructs users on putting in a t...
I have two clusters using ILS GDPR and call routing is working great. I can see directory uris being synced. However, I would like jabber users in each cluster to be able to search for users in the other without using LDAP. Currently jabber user...
Hi Community,I am troubleshooting one issue with search function for jabber running UDS Directory. If start typing last name of the user it works everytime and the match is correct. If I start typing number of the user it doesnt work at all. I have t...