If the problem affects only messages from outside callers, the issue may be as simple as signal gain at the voice gateway. If all calls are affected, then for Cisco Unity versions without Automatic Gain Control (AGC), the Cisco Unity-CM Telephony Application Programming Interface (TAPI) Service Provider (TSP) wave gain playback and recording settings may be set too low.
To resolve this issue, perform these steps:
If only outside callers are affected, check the voice gateway gain and attenuation levels. For instructions on how to adjust attenuation and gain, refer to the the appropriate documentation for your configuration at Cisco Gateways.
For Cisco IOS Software, use a negative decibel (dB) value when issuing the input gain command that is applied to the appropriate voice port to boost the signal if necessary.
Are snapshots still an unsupported option for all Cisco UC nodes? I have to upgrade a single node CUCm system to 12.5 SU4 (from 12.5) and while I am confident all will be fine, I have a 3 hour window to get the upgrade finished, switch version and get all...
Could you please advise if i can get the Attendant console client software and used it with the CUCM version 11.x ? I'm trying to link some Directory Numbers to the software so that the receptionist may answer call from the loaptop.
hi friends,we have a cisco 2911 router, and it connected to an E1 line from telco,problem is when we call to a number which is busy, router will detect busy-tone after ~40 seconds... i want to define custom-cptone, frequency and cadence, and then app...
I am wondering if someone can help me understanding e164 dial plan----what is the MAIN idea behind it? Why do I have to change a number (Ingress) to a +1XXXXXXXX format and then change it back to normal 10 digits before call goes out to PSTN (egress)?