After a call handler is configured who accepts caller input, with attempt transfers to subscribers, the call is not transfered to subscribers on caller input, and instead Cisco Unity instead generates an error in Event Viewer. The cannot complete your call as dialled error message is the annunciator announcement.
This is the erorr message in the application log:
The description for Event ID ( 504 ) in Source ( CiscoUnity_PHGreeting ) cannot be found. The local computer may not have the necessary registry information or message DLL files to display messages from a remote computer. The following information is part of the event: IAvDohMailUser::get_PrimaryMailbox, 0x8004010f, 6059, e:\views\Unity22.214.171.124\un_Conv2 \AvConvPhoneHandler\AvConvPHGreetingSvr\AvSPlayGreeting.cpp, For more information please click on http://www.CiscoUnitySupport.com/find.php
The issue is addressed in Cisco bug ID CSCed75076.
The problem occurs when the FullMailbox feature is enabled on Cisco Unity.
This is the registry key:
HK_LocalMachine\SOFTWARE\Active Voice\Conversations\1.0\Greetings\. The key name is "FullSubMBoxChkForOutsideCaller".
If the key is set to 1 then this feature is enabled. This feature is disabled by default, and the key is missing by default.
The defect is resolved in Cisco Unity 4.0(4).
If you do not wish to upgrade, the workaround provided is to check and modify this registry in the Cisco Unity server:
One particular agent not able to get into ready state.It will give error as below:"Operation errorThe Operation timed out or failed. Please try again or contact the administrator"if tried to click logout button it will be shown in the dropdown as below:"U...
Dear, I bought this used device and already managed to update its firmware to SIP, it's with version SIP70.9-2-1S, and it's working perfectly with Asterisk. I need to configure the softkeys to make the device as simple as possible, since it will...
Dear, I bought this used device and already managed to update its firmware to SIP, it's with version SIP70.9-2-1S, and it's working perfectly with Asterisk. I would like to access the device via SSH. I've already done the configuration in SEPMAC...
Dear, I bought this used device and already managed to update its firmware to SIP, it's with version SIP70.9-2-1S, and it's working perfectly with Asterisk. Now I would like to configure his interface for Brazilian Portuguese. All material I fin...
Hello , I am using a ISR4451 with an NIM-4E/M card. The router is configured with a 4 wire, type 5 voice trunk between an E/M port on the NIM and another router's E/M port elsewhere. The trunk is connected and is working properly. On older...