When the user tries to upgrade a standalone Cisco Security Agent for Cisco CallManager 4.x, the upgrade fails with the Unable to obtain the product ID for the standalone agent. Setup will now abort error message
Phones on our voice vlan do not get a dhcp assigned ip address. However the computers connected to the switch do get an ip address on the access vlan. The switch has a trunk port going to the upstream switch and that looks fine. Any ideas?
Calls to some of our registered SX10/SX20 endpoints (usually from Zoom, but not always) end up with one-way video. The media paths shown in xstatus are address of the far-end system. There does not seem to be any obvious way to get our e...
Hello, We currently have SRST's at many remote sites. Each site has approximately 5-10 POTS lines which cost $20-$40/each depending on site. I was curious if it's possible to use something like cellular instead of POTS lines for this.&nbs...
We've just went from 10.5 to 11.5, and now, we're unable to maximize/stretch-to-fit dashboards. Previous versions allowed us to do so. This issue has been duplicated across multiple browsers. Any ideas?