In simultaneous dual port operation, when the selected codec is G.729a, it is available to only one of the two Foreign Exchange Station (FXS) ports on a first-come-first-served basis. The port for which G.729 is available is configurable. The first port is available by default. The other port on a Cisco Analog Telephone Adaptor (ATA) is limited to G.711 because the Cisco ATA 186 has only one G.729a codec.
To resolve this issue, perform these steps:
Access the Cisco ATA 186 configuration screen from a web browser by entering the URL http://ip_address_of_ata/dev, where ip_address_of_ata is the IP address of the ATA 186 you are registering.
If the TXCodec and RxCodec are set to 3=G.729a, then the Low Bit Rate (LBR) codec must be set to 3.
Setting the LBR codec to 3 means that G.729a is available to one of the two FXS ports on the first-come-first-served basis. The other port can be configured to negotiate the use of G.711.
Note: The default configuration is for one port to use G.729 and the other port to fail. This may not be desirable for the second call to automatically use G.711 because of bandwidth consideration. To allow the second call to be successful, a codec class must be configured on the gateway to negotiate the second call using the G.711 uLaw or the G.711 aLaw.
Determine which port uses G.729 by configuring bit 21 of the ConnectMode parameter. Setting this parameter to Ox90 200400 makes G.729 available to the second port. G.729 is available to the first port by default.
As an alternative, set the RxCodec and TxCodec to G.723 and all calls can be supported simultaneously with this LBR codec.
The spa303 has a Voice Mail Server field under extensions. I want to arbitrarily control the Message Waiting Indicator(MWI). "The SPA phones will subscribe to the VM server and the MWI status will be updated via NOTIFY messages"&n...
Hi everyone, can you help me?I want to make a conference call from DN 1000 to Ten other users in CUCM How can I do that?I changed the default of Multiple Call/Call Waiting Settings to 10, but when the user arrives at 4 users I can't add moreI used th...
Hello Experts,Please find Attached,I have a cisco 2911 with CME and recently bought a sip trunk with a local provider, but i can't get it works.the provider Provided a LAN cable from there MDU Box and they provide a static IP address, subnet mask, an...
Dear all I have 9971 phone and I am trying to perform a factory reset and the phone is not resting also in the setting menu I do not have administrative setting icon there is only call History and running application ...
Hello Community, Need help with below.I have setup as PRI > 4800 > CUCM 11.5 > vg224 > FaxAttached are configs.When I dial fax DIDs 4800 shows call under "sh voice call status" but same call does not go to VG224 and to fax. Please advise....