cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

567
Views
8
Helpful
5
Replies
Highlighted
Explorer

Agents are logged in and in the 'Ready' state but call is not passed to them

Hi All,

A supervisor has reported a re-occuring intermittant problem.

It seems that his agenst are logged in and 'ready' but calls sometimes remain in the queue and are  not passed to the agents.

I need to begin the troubleshooting process here and hopefully find a way of documenting what is happening.

If anyone has any ideas or has seen a similar problem, the information would be greatly appreciated.

The CCX version is  8.0.2.11002-3

The Supervisor -  is running version 8.0.2 (premium version)

Regards

Amanda

Everyone's tags (5)
1 ACCEPTED SOLUTION

Accepted Solutions
Engager

Agents are logged in and in the 'Ready' state but call is not pa

HI Amanda,

Only the UCCX Administrator can view the Real Time Reporting in UCCX.

Users with Reporting capability can view the Historical reports (HRC client).

Hope this helps.

Anand

Please rate helpful posts !!

View solution in original post

5 REPLIES 5
Engager

Agents are logged in and in the 'Ready' state but call is not pa

Hi Amanda,

Are you only referring to CSD window to check the status of the Agents ? Request you to please view the status through UCCX Real Time Reporting tool because sometimes the Agent ststus changes are immediately not getting reflected on the CSD window.

Hope it helps.

Anand

Please rate helpful posts !!

Agents are logged in and in the 'Ready' state but call is not pa

Hi

I would carefully check over the assignment of skills/csq etc. If using skill based, verify what skills the CSQ that had the call had assigned, and at what minimum competence.

Then check the agent in question, and verify that the agent had those skills and at least the same or higher competence in each.

Aaron

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
Explorer

Agents are logged in and in the 'Ready' state but call is not pa

Hi Anand,

Thanks so much for your reply.

I have one question please.

Is there a way to make the Real Time Reporting tool available to a supervisor without granting him administration rights on the server?

regards

Amanda

Engager

Agents are logged in and in the 'Ready' state but call is not pa

HI Amanda,

Only the UCCX Administrator can view the Real Time Reporting in UCCX.

Users with Reporting capability can view the Historical reports (HRC client).

Hope this helps.

Anand

Please rate helpful posts !!

View solution in original post

Agents are logged in and in the 'Ready' state but call is not pa

Hi

That's not true - Supervisors and Admins can access real time reporting. Just log into AppADmin with a Supervisor account and you get a limited view of the system which includes RTR.

Aaron Harrison

Principal Engineer at Logicalis UK

Please rate helpful posts...

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
CreatePlease to create content
Content for Community-Ad
FusionCharts will render here