cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

667
Views
0
Helpful
1
Replies
Highlighted
Beginner

CAD Not Ready State

                   I have an agent, when in the ready state and they get a call on their private line and don't answer it, it puts them in the not ready state with the reason code (ring no answer). The agent has to put themselves back into the ready state. Please Advise. Thank You.

1 ACCEPTED SOLUTION

Accepted Solutions
Engager

CAD Not Ready State

Hi Robert,

If the above query is related to UCCX, CAD component.

Please access the UCCX System parameters page, and change the state of RONA to Ready state, by default it is set to Not Ready state.

Please note that this aaplies to all the Agents in the UCCX, if someone doesn't answer the call it will again put it back to Ready state.

Hope it helps.

Anand

pls rate helpful posts !!

View solution in original post

1 REPLY 1
Engager

CAD Not Ready State

Hi Robert,

If the above query is related to UCCX, CAD component.

Please access the UCCX System parameters page, and change the state of RONA to Ready state, by default it is set to Not Ready state.

Please note that this aaplies to all the Agents in the UCCX, if someone doesn't answer the call it will again put it back to Ready state.

Hope it helps.

Anand

pls rate helpful posts !!

View solution in original post

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here