09-02-2008 02:32 AM - edited 03-14-2019 02:49 AM
Hi all,
We have upgraded our Cisco Callmanager version 4 to version 6.
After the upgrade and the license upload, when we start the Cisco Communications Manager service, it starts for a few seconds then goes to not-running state.
Did anyone face the same problem?
Thanks
09-02-2008 03:55 AM
Please note that the syslog message preceding the callmanager service crash is :
%CCM_CALLMANAGER-CALLMANAGER-3-NoFeatureLicense: No feature license found
We verified the license unit report and we can confirm that the server license unit is ok.
What may be the reason for this failure?
10-14-2008 08:23 AM
I have the same problem. Was your problem fixed with a new license file?
10-14-2008 11:03 AM
Please refer to the following URL, particularly the POST install checks:-
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/upgrade/6_1_2/upgrd612.html#wp38623
It is important that you obtain the software feature license otherwise the callmanager service will not start.
The following information is taken from the 6.1.2 Release notes:-
http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/rel_notes/6_1_2/cucm-rel_note-612.html#wp474586
Cisco CallManager Service Stops After Upgrade to Cisco Unified Communications Manager 6.X
After you upgrade to Cisco Unified Communications Manager 6.X from a compatible Cisco Unified CM 5.X release, the Cisco CallManager service does not automatically run, even though Cisco Unified Serviceability shows that the Cisco CallManager service is activated.
Immediately after you complete the upgrade, upload the software feature license that is required for Cisco Unified Communications Manager 6.X in Cisco Unified Communications Manager Administration, and restart the Cisco CallManager service in Cisco Unified Serviceability. Until you perform these tasks, devices fail to register with Cisco Unified Communications Manager.
For more information on licensing, refer to the licensing chapters in the Cisco Unified Communications Manager Administration Guide and the Cisco Unified Communications Manager System Guide.
Rgds
Allan.
12-18-2008 10:46 AM
I have this same problem. Only I initiated a switch versions from 6.1.2 to 6.1.1 and now when 6.1.1 comes up it gives me this error NoFeatureLicense. When I switch back to 6.1.2 everything works fine. Since I'm going back to 6.1.1 why do I get this error if 6.1.2 can see the licsense just fine?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide