In my lab set up the calls are not coming to ICM. Calls getting dropped at CVP Voice browser. CVP PG is not getting any event of the call( VRU PIM is active). Any clue abt this?
15:23:28 Trace: 00000005: CALLFLOW: New call: From IP address=192.168.1.60 ANI=3333 To DNIS=1234, stackID=108809d4 : DNIS = 1234 : CID = DEFFDE772BEC11D6801CD1AF09D3A102
15:23:35 Trace: 00000005: CALLFLOW: Call ended : DNIS = 1234 : CID = DEFFDE772BEC11D6801CD1AF09D3A102
15:23:40 Trace: 00000006: CALLFLOW: New call: From IP address=192.168.1.60 ANI=3333 To DNIS=1234, stackID=10880bec : DNIS = 1234 : CID = DEFFDE772BEC11D6801CD1AF09D3A102
15:23:45 Trace: 00000006: CALLFLOW: Call ended : DNIS = 1234 : CID = DEFFDE772BEC11D6801CD1AF09D3A102
Solved! Go to Solution.
Thanks. Will do it and let u know the result.
One doubt here After creating this my call flow will be like below right?
IP Phone connected to CUCM-------> VG --------> Gatekeeper ---------> CVP----------->ICM
No , the call flow will be :
CUCM -> Gatekeeper -> CVP -> ICM
I am sure you know this , there are two types of gateways on cisco (both should be configured) ingress and VXML
The ingress gateway has the PSTN termination and a dial-peer to forward the call to the CVP (either using gatekeeper or direct)
the VXML gateway which the VXML scripts is terminated and cahced on .
Inyour case calling from internal , there is no need for the gateway to be involved .
However i do strongly recommend to change the gatekeeper zone prefix config from * to 1234 since that you have to change it one it is working so you cann either forward the call to the CUCM or the VXML gateway.
After the CCM configurations, calls are successfully hitting the ICM scripts thru CVP Thanks a lot!
Now my task is to configure VXML gateway and play some promts.
You are welcome, now close this discussion by marking the correct answer in any of the feedback , if you have a problem with the VXML , i suggest to open a new thread with a new subject so that can others can interfere.