cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
686
Views
0
Helpful
6
Replies

Cannot add local static routes in CVP Ops console

ln33147
Level 4
Level 4

Dear all,

I have installed the CVP 9.0 components and I am now in the phase of configuring the Call Server via the Ops Console.

I have already added the call server, but when I'm trying to configure the SIP subsystem, the Local Static Routes buttons (Add and Remove) are grayed and I am not able to add any route.

Kindly, is there any missing step that I should have done before adding a route?

Any help would be greatly appreciated.

Thank you in advance.

 

 

6 Replies 6

Kartik Bhatia
Level 1
Level 1

 

When you say Local Static Routes do you mean Dial Number Patterns?

Also on the Call Server - SIP Tab -are the Use DNS SRV and Resolve SRV localy checked & enabled?

Kartik

 

Also, have you added any CallManagers or Gateways to CVP OpsConsole yet? As I believe only they can be pointed to by a static route.

Kartik

Sasikumar Divvela
Cisco Employee
Cisco Employee
 

Hi, 

Enable Override System Dialed Number Pattern Configuration check box under sip tab, then Add and Remove buttons gets enabled. Please see the attached document.

 

Thanks,

Sasikumar. 

Thank you Sasdivve for the help

Best Regards,

is the issue resolved Laranoueir ?

Thanks,

Sasikumar.

Yep :) Thank you

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: