cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

CCX Finesse CTI Error 88407

Sheraz Saeed Lodhi
Participant
Participant

Hi Folks,

We have CCX 10.6.1 with Finesse. One of our newly added supervisor is not able to perform Silent monitoring while other supervisors are working fine on other extensions.

On Finesse it gives us the error Agent Device does not support Silent Monitor CTI Error= 88407. While other supervisors can silently monitor the same agent.

Check the attached screen shot for reference.

Thanks in advance.

4 REPLIES 4

Ramamoorthy Shanmugam
Rising star
Rising star

Hi,

 

Below points to be applicable for new supervisor Phone configuration .

 

--Phone BIB ( build in bridge ) should be on

--Supervisor and Agent Phones are in same Partition

--Supervisor – line Monitoring CSS need to be assign

 

Check the supported phones model for silent monitoring for version 10.5.6 .

 

If above  setting are in place , please remove the new supervisor from Members and supervisor list and add it again .

Ramamoorthy.S

Regards,
Ram.S

Hi Ramamoorthy,

All mentioned above steps have been taken before and checked but the result is same. Even I have removed and added the user from supervisor and member list but no use.

Phones is supported with SCCP for finesse 10.6.1.

Deepak Rawat
Cisco Employee
Cisco Employee

Refer to below post and verify the settings again:

https://supportforums.cisco.com/discussion/12727356/uccx-106-silent-monitor-generic-error

Regards

Deepak

cristian.munoz
Enthusiast
Enthusiast

HI Sheraz

I have the same problem. In my case the same Supervisor can silently monitor to some agents and no others.

CCX 11.6 and  IPCC.

TIA
Cristian

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: