I am using standalone CVP and I have installed VVB at the hub site. All calls coming from the branch gateway are configured to be sent to the VVB. How can i configure survivability on the ingress gateway? Here is the configuration on the gateway:
connection plar 2000
dial-peer voice 2 voip
session protocol sipv2
session target ipv4:X.X.X.X
dtmf-relay rtp-nte h245-signal h245-alphanumeric
(X.X.X.X is Virtual Voice Browser)
dial-peer voice 10 pots
There is no application configured on the gateway yet.
I want to find out how many agents are configured for an attribute. I have followed all the steps which are provided by the Cisco UCCE 11.6 API guide but I could not get the count. Is it possible to get a count of agents or not?
Collaboration Management Knowledge Base
For one-on-one help with these products, you can open a ticket at https://developer.cisco.com/site/support/. For other products, please contact Cisco TAC at https://www.cisco.com/c/en/us/support/index.html
Lately I have received a few requests from people asking if it was possible to Archive a Webex MessageSpace as in "download all messages".Interesting.
You can download all messages using the messages API but that leaves yo...
On May 10th 2021 a new API component was added: SPACE Tabs!
We call them ROOM tabs to be consistent with the room (space) API. Room Tabs represent an always available tab that is added as a tab in the space. It is co...
In a previous article I talked about the Cards & Buttons functionality of Webex Message. It's great to send nicely formatted or interactive messages.
What if you want to learn about Cards? There is a bot that teaches you all about Cards using...