cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

444
Views
0
Helpful
1
Replies
Highlighted
Beginner

CIM 4.3.1 Adding EIM_MRD for Interruptible on same PG after config wizard already run.

We have been up and running on CIM for a couple of years with non-interruptible agents.  Now we would like to add an interruptible EIM_MRD to the same PG we already have in place today.  Our thought is we could have some skills associated with the non-interruptible MRD and some with the interruptible MRD.  Since we ran the wizard ages ago to select the MRDs, how do I get this new MRD to show up within CIM for association with my skill?

1 REPLY 1
Advocate

Re: CIM 4.3.1 Adding EIM_MRD for Interruptible on same PG after

This came up recently when Kim Vogler of Cisco TAC had an open thread answering CIM questions. You could search for her thread. I know, because I asked a similar question about integrating a second PG/Listener.

Essentially you just need another Application Path Member for your new MRD on the existing peripheral and CIM will see the config information and the skills, DNs etc. My experience was that this was immediately available and no restart of CIM was required.

Post back your results, please.

Regards,

Geoff

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here