cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1581
Views
5
Helpful
2
Replies

Cisco_Twilio_Incoming Call failing

Hi,

 

I've setup a Elastic SIP trunk using Public IP NAT'ting towards Cisco Voice Gateway.

 

Twilio(Elastic SIP Trunk)-->Public IP NAtting--->Cisco Voice Gateway--->CUCM

Public IP-115.111.182.150

 

We are trying a establish a incoming call using the above call flow.

Am able to see calls in Voice gateway. But I See few errors like SIP/2.0 100 Trying or SIP/2.0 404 Not Found.

 

The way I setup the call routing is when I call the main number (2177714466) the call is supposed to get routed to Cisco CUCM.

 

Translation Rule created is,

voice translation-rule 3
rule 1 /^\+/ //

 

voice translation-profile NEW
translate called 3

 

Dial-Peer:

dial-peer voice 7011111 voip
translation-profile incoming NEW
destination-pattern 721..
progress_ind alert enable 8
session protocol sipv2
session target ipv4:10.131.62.146----
CUCM IP
session transport udp
incoming called-number .
voice-class sip rel1xx supported "100rel"
voice-class sip profiles 1
no voice-class sip reset timer expires 183
dtmf-relay sip-notify
codec g711ulaw
no vad

 

Attaching the VG Configs and debugs. Can you guys help to sort out this issue

 

 

Regards,

Anto

 

 

2 Replies 2

Vitthal Thutte
Level 1
Level 1

Define your incoming DNIS in "incoming called-number" and test once.

 

dial-peer voice 7011111 voip
translation-profile incoming NEW
destination-pattern 721..
progress_ind alert enable 8
session protocol sipv2
session target ipv4:10.131.62.146----
CUCM IP
session transport udp
incoming called-number 90046812400521
voice-class sip rel1xx supported "100rel"
voice-class sip profiles 1
no voice-class sip reset timer expires 183
dtmf-relay sip-notify
codec g711ulaw
no vad

 

INVITE sip:90046812400521@115.111.182.150 SIP/2.0

Via: SIP/2.0/UDP 193.46.255.79:63702;branch=z9hG4bK1001664554

Max-Forwards: 70

From: <sip:620@115.111.182.150>;tag=347059791

To: <sip:90046812400521@115.111.182.150>

Call-ID: 111393798-1473263611-2106785414

V T

AntoSathish8587
Level 1
Level 1

Hi,

 

Have made few changes in the Translation rule and in the dial-peer,

voice translation-rule 3
rule 1 /.*/ /72100/

 

 

dial-peer voice 7011111 voip
translation-profile incoming NEW
destination-pattern 72100
session protocol sipv2
session target ipv4:10.131.62.146
incoming called-number .
no voice-class sip reset timer expires 183
dtmf-relay sip-notify
codec g711ulaw

 

Now calls are getting connected.

But the issue here is once call is getting connected and if I accept the call in Cisco phone immediately calls are getting disconnected 

 

Also I see "delay media to slow start case, codec negotation is not done" in the debugs.

 

Attaching the debugs and configs.

 

Could you guys help on this issue.

 

Regards,

Anto 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: