CUSP pre-normalization vs. dial-peer and voice translation rules
I was hoping to consolidate as much dial-plan and digit manipulation as possible in CUSP but am having issues finding decent documentation (and examples) on how to effectively utilize pre-normalization policies. The Telco is delivering 4 digits DNIS/DIDs that need to be expanded to 10 digits and then based on the assigned prefix routed to CVP/ICM, non-agent phones on a call center CUCM cluster, or another cluster altogether.
Because of this I am expanding them on the ingress gateway via voice translation rules. The call center related DNIS numbers are scttered throughout the larger range so there are quite a few exact match dial-peers configured in order to get the correct routing. This effectively means that the routing decision is made at the gateway ( by assigning the prefix there) as opposed to centralizing it at the CUSP.
One of the items I could really use is better information on what regular expressions CUSP accepts. CUSP seems to see the . (period) as a literal rather than a wildcard and does not seem to like what we commonly use in IOS. Should the regular expression be enclosed in "" as in grep or egrep?
It would also be helpful to get better details on the "rules of engagement" on how the normalization policies actually work. If I configure the module as shown below p6980 will work but p6990 will not. If I change the trigger sequence number for p6990 to 5 then it does fire, but p6980 is then broken.
policy normalization p6980
uri-component update TO all user ^698 899222698
uri-component update request-uri user ^698 899222698
policy normalization p6990
uri-component update TO all user ^699 899222699
uri-component update request-uri user ^699 899555699
policy lookup cvp-policy
sequence 1 cvp-routes request-uri uri-component user
Hello, It seems if I use BAT to export all phones from a particular CSS I don't get any information on 796x phones that shows how many DNs are configured on that phone. I only see line 1. Am I missing something? CM 10.5 &...
Hi,Nous rencontrons un probleme d'audio sur les appels depuis jabber mobile et specialement vers des ponts de conferences. l'utilisateur nous signal que l'audio se coupe au milieu de l'appels.en attendant de reproduire le prob et d'avoir plus d...
Hello, When calling outside, the codec is sent to g729. So, if you proceed with a conference call, the call fails. In Voice Gateway, the codec was set to g.711. However, if it is sent to the outside, it is sent to g.729 and the c...
Good afternoon, I have a Cisco IP PHone 8851 with PID: CP-8851-K9 V01 with firmware 12.1.1. I was under that impression that this phone requires MPP firmware to work with third party sip provider such as voip.ms, telzio etc. Can someone advise if wit...
Hi,We have a requirement to enable Encryption on phone security profile for jabber clients, I configured this, but after that the user is not able to login from Jabber over MRA, it gives an error saying wrong username and password. However the same user c...