cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
461
Views
0
Helpful
1
Replies
Highlighted
Beginner

CVP 11.0 overriding Translation Profile - PCCE

Hi All,

 

Currently I have an issue where when I put the "service survivability" command under the incoming dial-peer, it seems to be overriding the translation profile on that dial-peer. This has become an issue because we are relying on the translation-profile whether or not the call is destined for Call Manager(11 digit) or CVP(10 digit). 

 

dial-peer voice 100 voip  <---Inbound Dial Peer
description "Inbound from PSTN"
translation-profile incoming PSTN-INBOUND <---Translation Profile to decide if number is Call Manager or CVP Bound
service survivability
session protocol sipv2
incoming uri via ATTSIPTRUNK
voice-class sip bind control source-interface Loopback1
voice-class sip bind media source-interface Loopback1
dtmf-relay rtp-nte
codec g711ulaw

 

voice translation-rule 100  <---Translation Profile to decide if number is Call Manager or CVP Bound
rule 1 /8183575047/ /8183575047/
rule 2 /^9496239773/ /9496239773/
rule 3 /^8189911153/ /8189911153/
rule 4 /^8183575000/ /8183575000/
rule 5 /^8186543490/ /8186543490/
rule 6 /^8183575051/ /8183575051/
rule 7 /^8183575100/ /8183575100/
rule 8 /^8059738700/ /8059738700/
rule 9 /^8666543471/ /8666543471/
rule 10 /^2133558988/ /2133558988/
rule 11 /^2138352828/ /2138352828/
rule 12 /^2138352820/ /2138352820/
rule 13 /^7148368266/ /7148368266/
rule 99 /^[2-9]..[2-9]......$/ /1\0/

 

voice translation-rule 200 
rule 99 /^[2-9]..[2-9]......$/ /1\0/

 

voice translation-profile PSTN-INBOUND
translate calling 200 <---Decide whether or not number is Call Manager(11 digit) or CVP (10 digit) bound
translate called 100 <--- Add prefix 1 to calling number making it a 11 digit

 

Is there another way to implement this translation-profile without interfering with CVP? From the documents I've read service survivability needs to be programmed in the incoming dial peer for Courtesy Call Back to work. 

 

I've seen in a PRI you can add the translation-profile command under the voice-port. Is there some kind of version of that for SIP connections?

 

 

Thank you in advance,

 

Bryan 

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Rising star

Just my $.02, but use 2 dial peers, one inbound from the PSTN with survivability, and then another dial peer for "outbound" that points to CVP with your translations, etc.

View solution in original post

1 REPLY 1
Highlighted
Rising star

Just my $.02, but use 2 dial peers, one inbound from the PSTN with survivability, and then another dial peer for "outbound" that points to CVP with your translations, etc.

View solution in original post

Content for Community-Ad