cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2128
Views
0
Helpful
9
Replies

ICM dynamic label transfer

hemal.mehta
Contributor
Contributor

For UCCE 8.X can anyone share info on how exactly a transfer happens using dynamic label.  We are transferring out to 800 no and somehow the calls sent out are not matching what is being received at the other end. 

9 Replies 9

Chris Deren
Hall of Fame Master Hall of Fame Master
Hall of Fame Master

The call is routed back to the routing client i.e. CVP or CUCM (wherever call arrived from) and follows dial-plan configured on the routing client i.e. CUCM Route pattern in matching partition or if CVP is involved either CUSP/CUPS/CVP dial-plan. If you are doing REFER transfer with CVP then the call gets routed back to the originating device i.e. ingress GW and a dial-peer is matched.

Chris

Do you know, if the dynamic label holds the leg after transferring outside. I have target requery enabled and it seems to come back after the call is over.

Yes, in order to release it you need to do REFER transfer to Label (typical recommended) for blind transfers.

Chris