ISN / CVP Lab Setup

[vipinkalra2000]

Hi,

I am planning to implement ISN / CVP in the lab scenario. After going through the product description/config giude, I am very much confused , how to go about it, I am totally clue less where to start from.

Any guidance please ....

Thanks in advance

[Riccardo Bua]

Hi Vipin,

I agree with you that starting to deploy a CVP without really knowing what to look for might prove quite challenging.

I would recommend reviewing the following guide quite some time was spent on writing it and if there are any enahnacement you would like to see in it, please feel free to rate the doc via the side link and provide your valuable feedback.

http://cco/application/pdf/en/us/guest/products/ps1006/c1097/ccmigration_09186a00803dfaca.pdf

Have fun!

[vipinkalra2000]

Hi

Thanks for link, I already have the installation and config/admin guide.

I was looking for more of a lab scenario based implementation.

Regards

[Riccardo Bua]

Hi,

if that is the case I suspect this is what you are looking for:

http://cco/en/US/products/svcs/ps11/ps5542/ps5546/ps5580/serv_datasheet09186a00801df0be.html

Regards

[vipinkalra2000]

Hi

By any chance can I get the lab excersie of this setup?

Thanks

[michael_oldham]

give me a call. I have installed a couple of ISN /CVPs todate and can help you out.