10-30-2008 03:58 AM - edited 03-14-2019 03:08 AM
Hello,
we have PRogger, AW/HDS, IP IVR ad CCM. So we use the following ICM script:
1. translate to VRU (IVR)
2. Run exteral script (CollectDigits)
3. Skill group Secretary.
4. Queueing
So when call is comming it ranlate to IVR. In IVR it is doing CollectDigits script. If caller enter digits, then call is transfered to this number. If caller don`t enter digits, call go to secretary. It is basicaly scheme.
So, how I can see all calls, that go through IVR? Now I can see only calls, that secretary was answer.The report is necessary for looking through in WebView.
Thanks
10-30-2008 06:24 AM
Look at the call type associated with your ICM script, that will tell you how many calls were sent to the IVR. Set up a call type before you send the call to the secretary and that will tell you how many calls were sent to that extension.
david
10-30-2008 06:34 AM
thanks, for your answer.
Am I correct understand, I should set up call type field before translate to vru.
10-30-2008 06:36 AM
Not really, that's redundant. You could do it that way, but since you already have a call type for that script so use that one. This assumes that your script is as simple as you describe.
david
10-30-2008 06:37 AM
You can find all your necessary fields from 'Termination_Call_Detail' table at awdb.
10-30-2008 06:44 AM
Should I configure something more or it is enough to set up call ype and select one call type before translation to VRU?
Thanks
10-30-2008 06:56 AM
10-30-2008 07:24 AM
Thank you very mach.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide