cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
410
Views
0
Helpful
2
Replies

Not Ready Reason Codes

Daweeks318
Beginner
Beginner

Is anyone familiar with configuring Not Ready Reason Codes in Desktop Administrator, more specifically creating a new one?  From all Cisco's documentation it should be a simple task.

However, when I create the new Reason Code in ICM Configuration Manager, it does not populate to the Reason Code list in Desktop Workflow Administrator.

The version of UCCE we are running is version 8.0.

2 Replies 2

Chintan Gajjar
Collaborator
Collaborator

check your CAD is synced with ICM, especially check the configuration for AW in CAD post install.

in CAD, reason codes automatically synchronises once configured in ICM. and then you can assign them to workflows.

you need to recycle the PG(CTI) services ..... if this isnt done

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers