02-28-2014 12:40 AM - edited 03-14-2019 01:10 PM
Hey everyone!
Does anybody know how to view configurtion of previously configured PIM (in case of cucm PIM - cucm ip address, jtapi user and so on...) ?
I know that we can do it in Peripheral Gateway Setup via choosing component and pushing Edit button. But it requires the process to stop, that is not very good in production.
Is there any way to view it without stopping PG process ?
Thank you.
BA,
Michael
Solved! Go to Solution.
02-28-2014 01:07 AM
Hi,
sure, if you know what you are looking for, it's in the registry. For instance:
HKLM\SOFTWARE\Cisco Systems, Inc.\ICM\
G.
02-28-2014 01:09 AM
You can check above configuration parameter via registry editor in PG.
Below is the path for CUCM/JTAPI related config,
Start-->Run-->Regedit-->HKEY_LOCAL_MACHIN-->SOFTWARE-->Cisco System,Inc-->ICM-->UCCE_Instance-->PGXX-->PG-->currentversion-->JGW-->jgw1-->JGWData-->Config
You can view all your configuration related CUCM PIM here.
02-28-2014 01:07 AM
Hi,
sure, if you know what you are looking for, it's in the registry. For instance:
HKLM\SOFTWARE\Cisco Systems, Inc.\ICM\
G.
02-28-2014 01:09 AM
You can check above configuration parameter via registry editor in PG.
Below is the path for CUCM/JTAPI related config,
Start-->Run-->Regedit-->HKEY_LOCAL_MACHIN-->SOFTWARE-->Cisco System,Inc-->ICM-->UCCE_Instance-->PGXX-->PG-->currentversion-->JGW-->jgw1-->JGWData-->Config
You can view all your configuration related CUCM PIM here.
02-28-2014 01:16 AM
Awesome!
Thank you.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: