PIM in PG is in CONFIGURED State

[Nguyen KeThuc]

Hi all,

I am using Cisco UCCE ver 10.0. I have two PIM (PIM2 and PIM3) for IP IVR1 and IP IVR2. So, I see that state of PIM2 and PIM3 Is CONFIGURED.

CTI Server 3B

nodeman.exe : 6.13:07:44

nmm.exe : 6.13:07:44

ctisrvr.exe : vinph-CG3B ctisvr - [ACTIVE ndanapg3b Port:43027] : 6.13:07:44

Peripheral Gateway 3B

nodeman.exe : 6.13:07:43

nmm.exe : 6.13:07:43

jtapigw.exe : vinph-PG3B jtapigw - jgw1 - [ ACTIVE ] : 6.13:07:26

mdsproc.exe : vinph-PG3B mdsproc - (InSvc Pr-Dsb Clk) : 6.13:07:26

opc-cce.exe : vinph-PG3B opc-cce.exe : 6.13:07:26

pgagent.exe : vinph-PG3B pgagent - (Not active) : 6.13:07:26

eagtpim.exe : vinph-PG3B eagtpim - pim1 - [DANCCM1 ACTIVE] : 6.13:07:26

vrupim.exe : vinph-PG3B vrupim - pim2 - [DANIVR1 CONFIGURED] : 6.13:07:26

vrupim.exe : vinph-PG3B vrupim - pim3 - [DANIVR2 CONFIGURED] : 6.13:07:26

testsync.exe : vinph-PG3B testsync : 6.13:07:26

Cisco ICM Diagnostic Framework

DiagFwSvc.exe : 10.12:44:17

I dumplog in PIM 3 in attached file.

Anyone help me to explain?

Thuc

[Reena Mundary]

Hi Nguyen ,

What's the PIM2 and PIM 3  status in Side A ? Are they Active ?

[Nguyen KeThuc]

Yes, They are active in Side A.

Thuc

[Reena Mundary]

If your Side A PIMs are active. It is normal for a non-active pim to be either in a "CONFIGURED" or an "IDLE" state.

When OPC initializes a PIM, the PIM goes from Idle, to Configuring, Configured,
Activating, and (possibly) Active.  If it cannot Activate, it will go Idle, and then try
again.

In a duplex environment - during a failover scenario - OPC will attempt to initialize the
PIM on both sides.  One side will go Active before the other can.  When that happens, OPC
informs the (now) non-Active PIM that its services are not needed, so it acquiesces, and
remains in whatever state it happened to be in at that moment in time.

[Nguyen KeThuc]

Hi Reena,

You mean these are  normal and don't worry about it.

Thuc