cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
499
Views
10
Helpful
6
Replies
Highlighted
Beginner

SocialMiner 11.0 Server Requirements

Looking for updated server TRC BOM to support SocialMiner 11.0. On the docwiki it shows UCS BE7K M3 only which is EOS. Is there a current C-series BOM (non-EOS) that can be used for SocialMiner 11.0 since the M3 TRC's are no longer available?

6 REPLIES 6
Highlighted
Hall of Fame Master

I would imagine the M4

I would imagine the M4 servers are supported and the docwiki simply has not been updated. My suggestion is to open PDI ticket if you are a parter to confirm, otherwise TAC case to have them let you know.

Highlighted
Enthusiast

Interestingly enough, the M4

Interestingly enough, the M4 servers are explicitily not supported according to the Sociaminer virtualization dockwiki.  

http://docwiki.cisco.com/wiki/Virtualization_for_Cisco_SocialMiner#Notes_on_UCS_Tested_Reference_Configuration_and_Specs-based_Support

"Where hardware support is specified as Limited, the following exception exists, as applicable to the TRC or Specs-based policy referenced: The UCS M4 generation of C series servers is not supported for use with any version of the SocialMiner application. All other UCS servers in the given TRC are supported."

Highlighted
Cisco Employee

http://docwiki.cisco.com/wiki

http://docwiki.cisco.com/wiki/Virtualization_for_Cisco_SocialMiner

Once you click on the M or L TRCs under the category of UCS Tested Reference Configurations in the Supported Hardware (Latest) section of the above mentioned dockwiki, it will take you to below link that lists BE7000M (M4) and BE7000H (M4) as the UCS Tested Reference Configuration:

http://docwiki.cisco.com/wiki/UC_Virtualization_Supported_Hardware#BE7000M_Servers_and.C2.A0Medium_UConUCS_Tested_Reference.C2.A0Configurations

Refer to below post as well:

https://communities.cisco.com/message/176492#176492

In nutshell, as far as you are using BE7K M4 as Specs Based, it is ok to install SM on it.

Regards

Deepak

Highlighted
Beginner

My apprehension and reason I

My apprehension and reason I was looking for clarification was due to the fact that under the M or L TRCs under the category of UCS Tested Reference Configurations it mentions UCS M3 only. I will take a look at the M4 Spec based (C240 M4S2 TRC#1).

Highlighted
Cisco Employee

No issue, feel free to go

No issue, feel free to go through the M4 specs based BOM to ensure that it meets your requirement. If you still have any confusion, let me know.

Regards

Deepak

Remember to Rate Helpful Posts so that it can help others with same kind of issues.

Highlighted
Beginner

Hi Deepak.

Hi Deepak.

I'm still confused; is there ANY version of SocialMiner which can run as the sole VM (no co-habitation at all) on a UCS-C220-M4S box? 

Thanks

~B

CreatePlease to create content
Content for Community-Ad

Cisco COVID-19 Survey