cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
552
Views
0
Helpful
3
Replies

UCCX 10.5 script not showing up for Debug

lmrscheff
Level 1
Level 1

When I select a script to debug, none of the scripts show up in the drop down list.  Not sure what is going on??

3 Replies 3

rossporubski
Level 4
Level 4

How are you able to select a script if none of the scripts show up?

Correction:  When I try to select a script to debug, none of the scripts show up in the drop down list. 

A few questions to preface the issue.

When did you upgrade or is this a new install?

Are you logged into Script Editor with admin authentication or annonymously logged in?

When was the last time you tried performing a reactive debug and scripts were visible?

Have you made any changes since then?

https://supportforums.cisco.com/discussion/11292101/uccx-851-crs-editor-reactive-debug

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: