cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
437
Views
0
Helpful
1
Replies

UCCX 8.0 (2) CAD desktop issue

lmrscheff
Beginner
Beginner

I have an agent when she get's a call she is not able to minimize her tool bar.  The system is switching in between partial service and in service.  Once the caller hangs up she is able to minimize her desktop.  This only happening to her no other agents.  Has anyone seen this before or could offer some troubleshooting ideas??

1 Reply 1

Mohamad Fayed
Beginner
Beginner

Hi,

This is something is better to be addressed in a TAC case in order to isolate the issue. Since it is happenning only for one agent, then it shouldn't be a major issue with UCCX, most likely it's a workstation\Agent device based issue.

Best regards,

Mohamad Fayed

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers