cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1825
Views
10
Helpful
7
Replies

UCCX agent desktop action buttons not showing

gary.heft
Level 1
Level 1

Hi All,

I've added some custom action buttons to the agent desktop interface to launch external scripts. The buttons show up on most of the agent desktop clients, but there are a small number that won't update to show the extra buttons. On top of that, every new desktop agent I install is also missing the buttons.

Has anyone else run into something similar?

Any help would be appreciated.

Cheers,

Gary

2 Accepted Solutions

Accepted Solutions

geoff
Level 10
Level 10

Did you do this in the "default" workflow or a custom workflow? If the latter, have you assiged the workflow to the new agent?

Did you make the buttons visible?

Regards,

Geoff

View solution in original post

Hello Gary,

That can be done under the Personnel configuration and if you have UCCX 7 you should go first to site A and after that go the personnel config.

HTH

Please rate this post if was helpful

Walter Solano

CCVP, Cisco UCCX Specialist

Cisco IP Communications Express Specialist

View solution in original post

7 Replies 7

geoff
Level 10
Level 10

Did you do this in the "default" workflow or a custom workflow? If the latter, have you assiged the workflow to the new agent?

Did you make the buttons visible?

Regards,

Geoff

Hi Geoff,

Thanks for the advice, you might be on to something. I added the buttons to a custom work flow group but I didn't think to assign the new users to it. I'm not actually sure how to do that and I couldn't find it in the documentation.

Gary

Hello Gary,

That can be done under the Personnel configuration and if you have UCCX 7 you should go first to site A and after that go the personnel config.

HTH

Please rate this post if was helpful

Walter Solano

CCVP, Cisco UCCX Specialist

Cisco IP Communications Express Specialist

Thank you guys very much for your help, I'm sure this will solve the issue. I wouldn't have found this on my own.

Cheers!

Gary

No problem Gary!!!

Cheers

HTH

Please rate this post if was helpful

Walter Solano

CCVP, Cisco UCCX Specialist

Cisco IP Communications Express Specialist

Walter Solano
Level 7
Level 7

Hi,

Did you try close CAD and reopen it, that needs to be done to apply any changes to a workflow.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: