UCCX Agent stuck in Reserved State when call gets transfered (direct transfer)
I have following issue:
CUCM 11.5.1 SU5
UCCX Inbound call arrives at Agent A
Agent A transfers the call to another CSQ Number with Finesse and is using direct transfer function.
Agent B gets selected and gets reserved - but finesse does not show any button to take the call (Cisco Jabber shows the incoming call, after taking the call - state in fiinesse still in reserved state) - it gets stuck in this state - even when the caller hangs up - it stays at this state for about 2 minutes. Manually changing to other state not possible.
BUT when Agent A transfers the call to another CSQ using Consult Transfer - type the number in finesse , say call and then transfer it the issue does not happen. It happens only with direct transfer - any ideas why this can happens ?
There are cases/situations where we have to configure custome CPTONE to resolve FXO disconnect issue. Following are situations which can arise due to FXO disconnect issue:
Phone A calls Phone B, Phone B does not answer. Phone A then goes on-hook but Phon...
Cisco announced major enhancements today to Webex Contact Center. Learn more about the highlights including
better support for the needs of large contact centers worldwide
improvements in the agent and cust...
SymptomsI’m doing a factory reset on the mobile board and it’s giving me the same issues that I wasn’t able to also send over last time. It says that it can’t connect to the server because of a firewall (we don’t have one) and then sometimes it...