05-15-2020 02:21 PM
New UCCX 12.5.1 system. After bringing up Pub/Sub, I have rebooted both, and gone into the CCX Servicability to set the Primary / Failover collector in the AMC Service configuration.
I set it, and hit save....the page just comes back and says ready, and the parameters don't "stick"
Suggestions?
05-15-2020 02:45 PM
You know, I think I just might have a suggestion for you... ;)
05-15-2020 03:34 PM
Nice to know there is a bug, but the bug report provides absolutely zero information about things like....was it saved and just not showing it? Did it not save? And the "fixed" version is (of course) not on CCO....
05-15-2020 06:10 PM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: