08-26-2012 05:00 AM - edited 03-14-2019 10:24 AM
After upgrade the uccx from 8.2 to 8.5 then application manager services are show in partical state.
Under UCCX service enginer.
application manager service are show ( PARTIAL_SERVICE).
I check the jtapi username and password are ok, I check the CTI route point and CTI port are registered.
Please can you help me on that how to resolved this issue.
08-26-2012 07:08 AM
Hi Ketanpatani,
Please run the JTAPI and Data Resyn operation from the UCCX Admin-> CUCM Telephony subsystem and look out for any inconsistencies between UCCX and CUCM.
Make sure all the CTI route points\ Triggers in enabled state.
If you have a UCCX HA setup, make sure to run all the services are in master state in UCCX Node1 (for this you can just reboot the UCCX second node so that all the services are running in master state from first Node of UCCX).
Thanks,
Anand
Pls rate helpful posts !!
08-26-2012 09:08 AM
Again thanks anand.
08-26-2012 09:32 AM
Hi Ketanpatani,
You are welcome.
Please don't forget to rate the helpful posts by clicking on the stars below the right\helpful answers.
Thanks,
Anand
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide