is there any way to play a beep after the prompt is played to enter digits using the "get digit string" step in UCCX? This is a configurable parameter using the "record" step, but not the "get digit string" step.
Is there any system prompt that can be used (as in : concatenate the custom "digit collecting" prompt with a system beep prompt, or is it required to embed the beep in the prompt referenced by the "get digit string" step (would be very cumbersome)
As Mike correcly pointed, all you need is just to add the beep prompt into the Get Digit String.
Hope this Helps
***Please rate helpful posts***
Thx Rath and Mike - but I was kinda looking for a built-in beep, not having to rely on an external prompt.
The start tone is not available for the get digit string step - only for the recording step - hence my question as I use the get digit string step.