cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1722
Views
0
Helpful
3
Replies

UCCX place call step unsuccessful (call status=6)

eeelizondo
Level 1
Level 1

Hi,

We have a problem with  a script when we do a place call step to  old PBXs that normally doesnt give us ring back the call goes to unsuccesful state, and if we call from an ip phone we dont heard the ring back but in 13-15 seconds the call is established, is there any parameter i can change to make the UCCX wait longer time before put the call in unsuccessful state?

Can it be because the call doesnt have a ringback tone?

I can ony see a timeout parameter but this is for a call that is placed, and its not answered, this put the call on  Call Status=2 (No answer)

We have :

CUCM 8.6.2

UCCX 8.5 SU3

E1 with R2 signaling

Any ideas?

Thanks in advance!!

3 Replies 3

Jonathan Schulenberg
Hall of Fame
Hall of Fame

This is a CUCM/gateway issue, not CCX. Start with this document:

http://www.cisco.com/en/US/tech/tk1077/technologies_tech_note09186a0080094c33.shtml

CCX just listens to what CUCM tells it. In this case CUCM likely believes that call setup never succeeded. Figuring out why you aren't getting ringback probably holds the solution to this issue.

Please remember to rate helpful responses and identify helpful or correct answers.

Hi,

But why with an ip phone the same call number call is established?

Another thing we also saw is that is not related with ringback, some calls doesnt have ringback and others have without any difference.

Any ideas?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: