UCS B series fresh install procedure

[Manjunath G]

I will be performing new ucce setup on new UCS B series chasis.

Havent have complete idea like where to start & what all config need to be done on UCS but known on ucs terminology.

can someone through lights on config parameter to start config steps to start with new UCS installation ,followed by any other inputs appreciated.

UCS H/w :   UCSB-B200-M3-U

Component mapping Requirement: Each Esxi will carry 6 nodes on it.

How much time requires to setup fresh install of 14 ucs boxes

Thanks

Manz

[anchoudh]

Hi Manjunath,

Please refer the below links for your current query,

http://docwiki.cisco.com/wiki/Virtualization_for_Unified_CCE

http://docwiki.cisco.com/wiki/Before_You_Buy_or_Deploy_-_Considerations_for_Design_and_Procurement

http://docwiki.cisco.com/wiki/Implementing_Virtualization_Deployments

Hope this helps.

Anand

Please rate helpful posts !!

[Senthil Kumar Sankar]

Hi Manjunath,

If you planning for install the UCCE on UCS servers. You can approach either by Tested Refence Configuration or Spec Based.

TRC's and Spec-Based configuration for specific Hardware is given in the below link.

http://docwiki.cisco.com/wiki/UC_Virtualization_Supported_Hardware#B200_M3_TRC.231

Regards,

Senthil.

[Manjunath G]

Our h/w suits under  B200 M3 TRC#1 based.

Thanks this is informative, however for the post install config iam referring to UCS config guide

Btw, iam wondering how to start acessing UCS , before to that i know we need to assign the IP's to device. Can you please help me where to perform the IP assignement inorder to access UCS

[Senthil Kumar Sankar]

Hi Manjunath,

For getting your UCS box configuration helps, I would suggest you post a thread under Unified Computing

Regards,

Senthil