cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
420
Views
0
Helpful
4
Replies
Manjunath G
Beginner

UCS B series fresh install procedure

I will be performing new ucce setup on new UCS B series chasis.

Havent have complete idea like where to start & what all config need to be done on UCS but known on ucs terminology.

can someone through lights on config parameter to start config steps to start with new UCS installation ,followed by any other inputs appreciated.

UCS H/w :   UCSB-B200-M3-U

Component mapping Requirement: Each Esxi will carry 6 nodes on it.

How much time requires to setup fresh install of 14 ucs boxes

Thanks

Manz

4 REPLIES 4
anchoudh
Engager
Senthil Kumar Sankar
Cisco Employee

Hi Manjunath,

If you planning for install the UCCE on UCS servers. You can approach either by Tested Refence Configuration or Spec Based.

TRC's and Spec-Based configuration for specific Hardware is given in the below link.

http://docwiki.cisco.com/wiki/UC_Virtualization_Supported_Hardware#B200_M3_TRC.231

Regards,

Senthil.

Our h/w suits under  B200 M3 TRC#1 based.

Thanks this is informative, however for the post install config iam referring to UCS config guide

Btw, iam wondering how to start acessing UCS , before to that i know we need to assign the IP's to device. Can you please help me where to perform the IP assignement inorder to access UCS

Hi Manjunath,

For getting your UCS box configuration helps, I would suggest you post a thread under Unified Computing

Regards,

Senthil

Create
Recognize Your Peers
Content for Community-Ad