I need to add a CUBE to terminate the SIP PSTN trunks in an existing environment. They have CVP 4.1 but will be upgraded to 7.x before the CUBE deployement. I will use a 3945 with IOS 15.001. They have a gatekeeper for call routing.
I want to know if anybody has any experience of the below call flow and if I may come up with any problems ?
I will probably need to use MTP ( Software on CUBE ). But as the connection from callmanager will not be directly to the CUBE, I think I should check the MTP Required box in the existing Gatekeeper controlled Trunk. Would this cause any issues ?
When using CUBE I've run come accross DTMF relay issues, specifically when the SIP carrier uses RFC2833. The best solution I've found when forwarding DTMF to any of the contact center products is to use a hardware transcoder and not a software MTP. This means you should plan for extra DSP resources in your router to handle the media termination to your CVP.
Please help us make the communities better. Rate helpful posts!
Thanks for the tip. But my question is, if the flow I mentioned may have any problems. At the moment They have two 3825 routers where the ISDN-30 lines terminate. They are also VXML gateways and they all use gatekeeper. I will be replacing one of the 3825 with a 39xx router whihc will terminate the new SIP PSTN trunk and will be used also as voice xml gateway.
Hello Admin Community!
I’m recruiting participants for an upcoming study looking at large meeting troubleshooting in Control Hub. If you’d like to participate, please fill out this quick, 2 min. survey. Thanks! https://www.surveymonkey.com/r/...
Don't you just hate having to run RTMT in a virtual machine, well here it runs in an app for mac. I have complied a version for CUCM 14.x ( from a version I got for 11.x ) It works on older versions also. Here it is https://haffi.is/rt...
To participate in this event, please use the button to ask your questions
Tour of the Real-Time Monitoring Tool
Have any questions about the Real-Time Monitoring Tool?
What is the Real-Time Monitoring Tool (RTMT) and how do I use it? In addition to...
This event will have place on Tuesday 20th, April 2021 at 10:00 hrs PDT
What is the Real-Time Monitoring Tool (RTMT) and how do I use it? In addition to an overview of the components of the tool and the interface, attendees wil...
The purpose of this document is to provide troubleshooting insight into a well-known issue for the IM&P nodes when going to the Presence Topology Page and seeing all the services as Unknown, even though they are started as shown on the ...