UUCX 9 agent status and call type

[Anas Abueideh]

Dear Experts,

I have an issue with agent status. when the agent make an outbound call (not preview dialer), the status is changed to "not ready" . is there any way to change it to "talking state" instead of "not ready".

the other issue, when you run the agent detail report, the call type sometimes is "outbound on IPCC" and sometimes is "outbound on non-ipcc".

the agent has only one extension, and all outbound calls are initiated from the agent (not preview dialer)

thanks in advance

Anas

[Jonathan Schulenberg]

Talking is only used on an ACD call. Direct inbound or outbound calls are considered Not Ready. You cannot change this behavior.

The second one, if in fact they only have a single DN on their phone, sounds like a defect. That might be worth a call to TAC if it impacts your operation.

Outbound on IPCC—Total
  Number of calls made by the agent on an IPCC extension, including calls attempted and calls connected. 
Outbound on non-IPCC—Total
  Number of calls made by the agent on a non-IPCC extension. This number includes calls attempted and calls connected. 

http://www.cisco.com/en/US/docs/voice_ip_comm/cust_contact/contact_center/crs/express_9_0/user/guide/UCCX_BK_UE5BE47D_00_uccx-historical-reports-ug_chapter_011.html

Please remember to rate helpful responses and identify helpful or correct answers.

[vikasgupta2k]

Hi,

We are having the same issue with the outbound calls reporting. Agents have only one extension on their phones and when they make outbound calls (using dial-pad on CAD or physical phone), it is showing up mostly on Outbound non-IPCC calls in the reports. We are running 9.0.2 UCCX. Any insight will be really helpful.

Thanks

[Ravi Shankar Pandit]

what is the exact UCCX version . Can you please attach one sample report..