cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
358
Views
0
Helpful
5
Replies
Frequent Contributor

VVB in cvp ops man

We currently have a 6x number of vvb located in remote locations and 2x vvb in our DC's  installed by our SI before I joined  I'm now adding  a vvb in a different location but when I look in ops man I can only see the 2x DC vvb's- why would that be? I thought you had to install/register each VVB in ops man so I thought I would see 8x vvb.

 

I have not logged on to local vvb yet to confirm if they are being used. Should I use show vvb call active voice summary to prove they are being used 

 

Any ideas 

Thanks 

5 REPLIES 5
Highlighted

Re: VVB in cvp ops man

By default without CVP route VVB cannot process any request please check the below

Check Dialed Number Pattern for Network VRU bootstrap Label in OAMP and VVB SIP Server Group or IP Address.

If you have CUSP check the VVB server group and elements.

For verification we can check in two way .

1. VVB -- show vvb call active voice summary
2. CVP call server logs check VRU label with VXML browser IP -- Contact: <sip:77777777775078@10.10.10.5:5060;transport=tcp>
Sending Message (NB): ACK sip:77777777775087@10.10.10.5:5060;transport=tcp SIP/2.0
Frequent Contributor

Re: VVB in cvp ops man

Hi, thanks for your reply, I'm aware that it needs dnp for routing which each one has  but my question was the lack of vvb's in the vvb configuration page of ops manager - only 2 of the 6 were "configured" on the page. Should not all of the vvb be on the page, why only 2

Contributor

Re: VVB in cvp ops man

Where are your CVP servers located? Are all of them in the one OAMP?

Also, and this may be unlikely but still possible, are you sure that only one OAMP is in use?

Frequent Contributor

Re: VVB in cvp ops man

Hi bill

 

Yes, we have a single ops man in a DC. We have 2x vvb,2 x cvp 2x vxml co-located in the DC as well with 6x remote vvb in our international offices 

Frequent Contributor

Re: VVB in cvp ops man

Further  Each remote vvb has ite own dial route pattern in dnp with sip route grps pointing to them. I would have thought that for every vvb, therr would be a vvb in device management section of ops man? 

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards