We have a call center of about 40 Agents and about 25% of our calls the Wrap Up Data pop up is not appearing. We are running Cisco Unified Contact Center Express 8.5.1. Anybody know where I can trouble shoot this or resolve it. Doing a search on Wrap up data I was unable to locate a similar problem.
For the calls that do not recieve wrap up data, do they have anything in common?
Are specific agents affected?
Are calls to specific queues affected?
Some things to check:
ensure all agents are assigned to the correct workflow in desktop administrator
ensure that all csq's where wrapup data should be displayed have wrapup enabled in the CSQ configuration
Please also check if Automatic Available option in the RmCm->Resources page for these specific Agents.
Accept the default (Enabled) to automatically put the agent into the Available state after the agent finishes a call and disconnects.
Note When a logged on agent in Ready, Not Ready, or Work state answers a call, the agent's state is subject to the Automatic Available setting. (See Creating a CSQ.)
And on the CSQ page,
Automatic Work :
Determines whether agents in this CSQ automatically enter Work state after a call.
Enabled: Causes the agents to go into Work state automatically when a call ends.
Disabled (default) : Causes agents to enter Ready or Not Ready state when a call ends, depending on the Automatic Available setting for the agent.
So please change these two parameters along with the correct worflow group in CDA (as Brain has listed above).
Hope it helps.
Please rate helpful posts..
Thanks for the replys. I checked everything that was stated and everything is correclty configured. It apears that the cause of this problem is realted to 2 things. 1. we have agents who skip the wrap up data. and 2 I changed a couple of the wrap up codes that they use and did not reset the Cisco Unified CCX Engine. After reseting the Cisco Unified CCX Engine the problem went down to about 1% which observation has showen that the agents are skipping the wrap up data.