How to install SD-Access

[DNAC]

When I installed DNAC, I found that the following functions are not available:
sd-access
sensor assurance
application policy
how do i install these features

[Alexander Stevenson]

Hi @DNAC,

I'm not a DNAC expert but I found a guide, which may be useful to you: Cisco DNA Center Second-Generation Appliance Installation Guide

Notes:

• All page numbers referenced are the PDF page numbers and not the numbers printed on the bottom of the page

• See Cisco DNA Center and Cisco Software-Defined Access on page 28

• On page 103, it reads "All installed packages should appear in the command output as DEPLOYED. In the following example, a few packages were not installed, such as the application-policy and sd-access packages. They are the only packages whose status is NOT_DEPLOYED. Your package status should look similar to this before configuring a secondary node." Similar wording is found on pages 152 and 201.

Hope this helps!