This documents provides steps to configure IP address for CIMC access to UCS C series servers.
Overview of KVM features:
1. Cisco C-Series Rack Servers provides a physical local video and two usb connections for a usb keyboard, video monitor, and usb mouse connection through the front panel of the Rack Server using the Cisco provided dongle connector.
2. All Rack Servers can have up to 4 active KVM over IP sessions in addition to the local connection at front or rear panels. All active sessions have full control of the console
3. KVM over IP supports text and graphics modes of the graphics controller and needs no manual setting to view data
4. Graphics modes supported are up to the video chips maximum capabilities of 1600 x 1200 with 16 bit color.
Configure CIMC IP address
Step 1: Boot the server. You will get the following screen. Note: if you miss the initial CIMC setup follow the unit’s power-up procedure Press (Y) to continue, next Press 9 then Enter to update all.
Step 2: Quickly Press the “F8” key to enter the “CIMC Config” setup before the UCS server goes into auto reboot.
Step 3: For the “NIC mode”, enable “Dedicated” and for “NIC redundancy” enable “None”. This ensures that the dedicated Management Port will be used for CIMC instead of the Intel NIC at port 1.
Step 4: To use fixed/static IP Address, disable the “DHCP enabled” option. Specify the required values for three options below : 1. CIMC IP 2. Subnet mask 3. Gateway
Step 5: To use DHCP, enable the “DHCP enabled” option
Step 6: Press the “F10” key to save the changed settings done so far.
Step 7: After 45 seconds, press the “F5” key to refresh the display.
Step 8: Press the “ESC” key to exit the CIMC Configuration Utility.
Logging In to CIMC
Follow these steps to login to the CIMC.
Step 1 In your web browser, type or select the web link for CIMC. Step 2 If a security dialog box displays, do the following: Click Yes to accept the certificate and continue. Step 3 In the log in window, enter your username and password. Step 4 Click Log In.
Hello, Could you check my config template, I just want to make sure that it makes a domain and works fine, I am about to put it on lot of switches. thanks a lot 5k-1#Config T
5k-1(Config-Fex)#Pinning max-links 1
Hi, Could anyone here please help clarify if I can configure either BIOS of Cisco 12G SAS Raid bios to have a standard SATA hard drive access? I am having a Cisco C220 M4 server with Cisco 12G SAS raid controller...
Hi,The APIC EP tracker does not give results when searched with VM name.FYI: Getting results when searched with same IP address.Has anybody tried this ? The tool tip shows as:e.g., 00:50:56:BD:2E:6C, 10.0.0.1 or 2002:50:22:0:50::1, or comp-vm1APIC ve...
I have 2 x 7009 chassis, each have 2 x SUP1 supervisors (NXOS 6.2(16)), 3 x M108X2-12L, 1 x M148GT-11L line cards and 5 x FAB2 fabric modules. These act as the core switches, with VPCs to downstream Nexus 5500s.I need to replace the modules in each 7009 w...
I have taken the following exams:(300-165)(300-175)(300-180)According to the migration tool, it says that with these 3 approved exams it is enough to have the new ccnp Data Center certification of February 2020. So here my question, I really only need to ...