This documents provides steps to configure IP address for CIMC access to UCS C series servers.
Overview of KVM features:
1. Cisco C-Series Rack Servers provides a physical local video and two usb connections for a usb keyboard, video monitor, and usb mouse connection through the front panel of the Rack Server using the Cisco provided dongle connector.
2. All Rack Servers can have up to 4 active KVM over IP sessions in addition to the local connection at front or rear panels. All active sessions have full control of the console
3. KVM over IP supports text and graphics modes of the graphics controller and needs no manual setting to view data
4. Graphics modes supported are up to the video chips maximum capabilities of 1600 x 1200 with 16 bit color.
Configure CIMC IP address
Step 1: Boot the server. You will get the following screen. Note: if you miss the initial CIMC setup follow the unit’s power-up procedure Press (Y) to continue, next Press 9 then Enter to update all.
Step 2: Quickly Press the “F8” key to enter the “CIMC Config” setup before the UCS server goes into auto reboot.
Step 3: For the “NIC mode”, enable “Dedicated” and for “NIC redundancy” enable “None”. This ensures that the dedicated Management Port will be used for CIMC instead of the Intel NIC at port 1.
Step 4: To use fixed/static IP Address, disable the “DHCP enabled” option. Specify the required values for three options below : 1. CIMC IP 2. Subnet mask 3. Gateway
Step 5: To use DHCP, enable the “DHCP enabled” option
Step 6: Press the “F10” key to save the changed settings done so far.
Step 7: After 45 seconds, press the “F5” key to refresh the display.
Step 8: Press the “ESC” key to exit the CIMC Configuration Utility.
Logging In to CIMC
Follow these steps to login to the CIMC.
Step 1 In your web browser, type or select the web link for CIMC. Step 2 If a security dialog box displays, do the following: Click Yes to accept the certificate and continue. Step 3 In the log in window, enter your username and password. Step 4 Click Log In.
Does anybody know an estimated end of sale date (EOS) for the Cisco MDS 9250i? We have been recommended this MDS switch but to my mind this product is way past its sell by date and should be sunset fairly soon. Thanks MDS 9250i
Hi,I had read thru many documents about PVLAN. Some how there some questions I need expert advice.Especially the PVLAN trunking , also the what is common practise interface type use for VMWARE ESXi host. Please open attached powerpoint fi...
To participate in this event, please use the button to ask your questions
This special event - formerly known as Ask the Expert- is open only to Cisco Customers and Partners.
Many pages in the Cisco Community are acce...
Greetings, out of curiosity how long does it take your APIC device to boot to the APIC screen?I'm seeing anywhere from 20-30 minutes. Sometimes requiring me to reboot multiple times to get it to appear.Working with C220 M5. More often then not I get ...
Hi all, after port change from fc to ethernet and restared N5K I have a problem with second N5K, this two devices are connected via peer-link and I´m receiving error log: %VPC-2-VPC_DELAY_RESTORE_TIMER: Delay restore timer will be overwritten to...