This documents provides steps to configure IP address for CIMC access to UCS C series servers.
Overview of KVM features:
1. Cisco C-Series Rack Servers provides a physical local video and two usb connections for a usb keyboard, video monitor, and usb mouse connection through the front panel of the Rack Server using the Cisco provided dongle connector.
2. All Rack Servers can have up to 4 active KVM over IP sessions in addition to the local connection at front or rear panels. All active sessions have full control of the console
3. KVM over IP supports text and graphics modes of the graphics controller and needs no manual setting to view data
4. Graphics modes supported are up to the video chips maximum capabilities of 1600 x 1200 with 16 bit color.
Configure CIMC IP address
Step 1: Boot the server. You will get the following screen. Note: if you miss the initial CIMC setup follow the unit’s power-up procedure Press (Y) to continue, next Press 9 then Enter to update all.
Step 2: Quickly Press the “F8” key to enter the “CIMC Config” setup before the UCS server goes into auto reboot.
Step 3: For the “NIC mode”, enable “Dedicated” and for “NIC redundancy” enable “None”. This ensures that the dedicated Management Port will be used for CIMC instead of the Intel NIC at port 1.
Step 4: To use fixed/static IP Address, disable the “DHCP enabled” option. Specify the required values for three options below : 1. CIMC IP 2. Subnet mask 3. Gateway
Step 5: To use DHCP, enable the “DHCP enabled” option
Step 6: Press the “F10” key to save the changed settings done so far.
Step 7: After 45 seconds, press the “F5” key to refresh the display.
Step 8: Press the “ESC” key to exit the CIMC Configuration Utility.
Logging In to CIMC
Follow these steps to login to the CIMC.
Step 1 In your web browser, type or select the web link for CIMC. Step 2 If a security dialog box displays, do the following: Click Yes to accept the certificate and continue. Step 3 In the log in window, enter your username and password. Step 4 Click Log In.
Hello, 1st question) If I have two 7k switches the connection would be something like this diagram for making a single domain,what will happen if I have a 3rd 7k and I still want a single domain, should I connect the both 7ks to the new one? 2nd...
Hi, I installed ACI simulator on a UCS c220 M4 server with a PID APIC-SIM-S2. Sometimes it crashes where we need to install over again. Is a way to take a snapshot when I can revert at crash times ? ThanksZulfi
We currently have 2 pods with 4 spines in each pod. Our current configuration is to only use 2 of the spines in each pod for the IPN between the pods. This gives us no single point of failure. Given there are no bandwidth constraint...
Hello. Could someone please help me understand how the STP works on the attached topology? Ports 10-11 are vPC peer link ports on all the Nexus switches. I went through the doc and it seems vPC peer link ports will NOT be in an STP blocking stat...
Hello everyone, I'm trying to copy an image from the TFTP server Solarwinds into the bootflash of the Cisco Nexus 3000 switch: Commands:#copy tftp: bootflash#<image>#<IP address of the TFTP server> Then comes the message: TFTP g...