This TAP has 77 new Flexpod related workflows. It heavily expands the UCS capabilities through the "Execute UCS Command" activity, the VMWare capabilities using PowerCLI, as well as extensive content around NetApp Oncommand (DFM) automation using the web service interface (via HTTP adapter).
EDIT: Whoops, it's not 99 workflows, actually it's 77 workflows and 22 targets, users, categories, variables etc.
There are five categories of workflows:
Storage (using NetApp DFM/OnCommand web services v4+)
Compute (using UCS HTTP)
VMWare (using PowerCLI)
Networking (using Terminal Adapter)
Portal (actually I meant to remove these, they are from the POC that I was doing when I created this TAP. Ignore these)
Most of the workflows are self-explanatory (e.g. "Add NFS Datastore to VM Hosts"), some are more obscure, but unfortunately I don't have the time to fully document everything. A lot of the UCS work is done around SP and vNIC templates, e.g. adding a VLAN to an updating vNIC template, adding a new datastore to all Service Profiles that were cloned from an initial SP template etc. DFM is slightly more complex as you have to have an understanding of how NetApp OnCommand provisions storage to know what it's doing.
To see some of the activities in this TAP in action, watch this video:
Is there anything special I have to do on VMware to get two 9000v's setup as a vPC pair? When I build the vPC, the link will come up and then throw the log up below and block all VLAN's from traversing the peer-link. If I put the same config o...
Dear friends, I am struggling to understand difference between extending EPG vs extending BD in normal SINGLE POD case-1 As i understood so far, Extending EPG means we will make EPG-10 and will add trunk ports in it (trunk port going ...
This may be the wrong place to post this question but I'm having a weird issue accessing the APIC GUI from my home internet. When on my ISPs service, I cannot access the GUI of any of my companies APICs. I can only ping the APIC IP with a max MTU size of ...