Join us for the next Cisco TechAdvantage Webinar for a second session focused on Cisco Dynamic Fabric Automation (DFA). This webinar builds upon the January 8th session and will provide additional insight as to the technical components of how DFA works followed by a live demonstration.
Cisco DFA is the industry's first to be optimized for both Layer 2 and Layer 3 at all points, simplifying application deployment (physical and virtual) and providing consistency (quality of service [QoS], availability of network services, user experience, etc.) at all points of the network for all kinds of deployments. It simplifies, optimizes and automates the data center (DC) fabric environment by offering an architecture-based on 4 major pillars (fabric management, workload automation, optimized networking, and virtual fabrics). Each pillar provides a set functions which are modular enough to be used independently so that the adoption of new technology is eased as the DC fabric architecture evolves.
Introduction and overview
Hands-on DFA Architecture
XMPP and PoAP Demonstration
Semi-Automated Workload Deployment
Fully Automated Workload Deployment with OpenStack
I have a nexus that when I log into the console it has a completely different hostname than what is set in the config. Where is this configuration stored or modifiable. Initially the prompt says TO-N7K:After I log in it says the actual hostname as th...
We have an ACI(Multipod) & F5 (ACT-STBY) setup in our environment build in Network centric mode. Some strange issue occurred in last migration, when we failover from Active to Standby and again back from Standby to Active F5 , it is seen that traffic ...
Hi, I have one l3out using static routes to reach some remote networks. Those remote networks I want to get them redistributed on another l3out running OSPF and, at the same time change the default tag since they will enter the ACI fabric later ...
Hello,a customer has a l3out to a firewall cluster (active/standby) with two leaf switches (leaf 101 and 102). Customer explained redundancy doesn't work. The l3out is done with routed interface. Each interface has an IP address from a /29 network.&n...
Hi, i have a scenario where in legacy 7K network we have multiple production servers running in vlan 1. In ACI, we cant create EPG with encapsulation vlan 1. Do we have a workaround how to move the workload from N7K to ACI without the need to re-id the vl...