Cisco's memory kits for UCS servers are separated into categories because of differing degrees of identical pairing required for each server model. Therefore, mix and match of memory from one particular model to another one might not be possible.
For example, taking DIMMs from a B440 to a B250 must not be done, as extended memory servers like the B250 are particularly sensitive to memory and have different requirements.
The recommendation is to comply with the Memory requirements included in the Blade Server Installation and Service Note for each model.
Refer the table below for information regarding different UCS server models and supported RAM.
I have an advance question about vPC design below. Basically I have two data centers connected as back to back vPC, and I have a requirement of connecting the below pair switches across the four aggregation switches. Do you think a scenario like this...
Hi board,I'm new to cobra and I am trying to install the SDK. I don't have access to an APIC server and the sandbox (https://sandboxapicdc.cisco.com) doesn't provide the SDK.So here's what I did: Cloning the GitHub repo (https://github.com/datacenter...
hello communityi'm having problems with a mac address in a vrrp group, so for some momentsthere is no fwd to that mac address so servers cannot reach their default gw when i send this command to the device that has the vrrp config and that mac s...