** NOTE :: please download the QSG PowerPoint file (pptx) attached below: as the website tool is capturing the first part of the animation and skewing the slides. **
This Quick Start Guide (QSG) is a Cookbook style guide to Deploying Data Center technologies with end-to-endconfigurations for several commonly deployed architectures.
This presentation will provide end-to-end configurations mapped directly to commonly deployed data center architecture topologies. In this cookbook style; quick start guide; configurations are broken down in ananimated step-by-step process to a complete end-to-end good clean configuration based on Cisco's best practices and strong recommendations. Each QSG will contain set the stage content, technology component definitions, recommended best practices, and more importantly different scenario data center topologies mapped directly to complete end-to-end configurations. These QSG's are geared for training network engineers, network operators, and data center architects to allow them to quickly and effectively deploy these technologies in their data center infrastructure based on proven commonly deployed designs.
The final part of the procedure is to run "switch# copy running-config startup-config" however, my switch stays at "switch(boot)" and will not allow me to do a "copy running-config startup-config" how can I get to just the "switch"" prompt without doing "...
Performed below steps to bring up the interface.1. Upgrade the NXOS from nxos.7.0.3.I7.6 to nxos 9.3.22. Removed the breakout configuration and reapplied the configuration as below. 2.1 no interface breakout module 1 port 31 map 25g-4x&nb...
Hi guys. On gen-2 switches is there a way to tell if an endpoint was learned based on ARP-content (like SHA, SPA)? Is there any command which shows something like a 'learned by ARP-content-flag'? ThanksMarcel
I have a removed device hanging in the intersight for more than 3 hours, it stucks at 75% and can not go any further. I'm not able to kill that (there is no option to choose), can anyone help? Thank you.
Hi All, I have a lab setup with 2 leafs and 2 spines and use VXLAN BGP EVPN. There is also a VPC peer link between the leaf devices. For some reason all traffic is being learnt via the peer link and not over the NVE interfaces, is there a reason for ...