This document contains the slides for the live webcast.
Cisco expert Vishal Mehta covered the features UCS and Nexus 1000v from a perspective of configuration, performance, best practices, and troubleshooting.
Cisco UCS: End-Host Mode (EHM)
Cisco Nexus 1000v
Configurations: Private VLAN, quality of service, multicast, load balancing, MAC trace and port channeling
Vishal Mehta is a customer support engineer for Cisco’s Data Center Server Virtualization TAC team based in San Jose, California. He has been working in the TAC for the past three years with a primary focus on data center technologies such as Cisco Nexus 5000, Cisco UCS, Cisco Nexus 1000v, and virtualization. He has presented at Cisco Live in Orlando 2013 and will present at Cisco Live Milan 2014 (BRKCOM-3003, BRKDCT-3444, and LABDCT-2333). He holds a master’s degree from Rutgers University in electrical and computer engineering and has CCIE certification (number 37139) in routing and switching and service provider.
I'm trying to understand how AVE VM two interfacesave-internal-1ave-internal-2VM adapters mapped to one single KNI interface(kni1) ? It looks like kni1 takes the MAC address of ave-internal-1. what happens to ave-internal-2 VM adapter? I don't see it...
Hello Experts,Do you guys have any experience or had a chance to apply Jumbo MTU commands with FCoE in production?I wonder if this can have any impact. Today this switches is just L2 and FCoE is running , but with MTU default. policy-map type n...
Hi, we have recently installed Cisco DCNM 11.2.1 and enabled AAA with Cisco ISE as TACACS+ server. At the Cisco ISE server I have configured the TACACS profile with the custom attribute set to Mandatory name shell:roles and value network-admin. Auth...
Hi there,When i look table 6 at https://www.cisco.com/c/en/us/products/collateral/switches/nexus-3548-switch/data_sheet_c78-707001.html , I see that the switching capacity is at 480Gbps. If i enable all 48 ports, will the switching capacity be t...