cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
configure & troubleshoot anyconnect

VSS configuration on Cat6500

657
Views
0
Helpful
1
Comments

Here is a sample VSS configuration for 2x Cat6500 with Supervisor 720.

VSS domain config:

switch virtual domain 10
switch 1
switch 1 priority 110
switch 2 priority 100
exit

Create a Port-Channel "mode on" type between two Supervsor:

interface port-channel 1
description VSL Link

switch virtual link 1

no sh

interface range T5/4 -5
channel-group 1 mode on

no shutdown

Commiting following command will save the configuration on both switches and reboot them.

switch convert mode virtual

After the reboot, we need additionally apply this command:

switch accept mode virtual

Now, lets verify the VSS status:

show switch virtual
show switch virtual link
show switch virtual role

Remember to apply this also:

mac-address-table synchronize

redundancy
mode sso
exit

Hope it helps


Comments
Cisco Employee

Pamiętaj tylko, ze port-channel powinien mieć inny numer na obu switch'ach!

Pozdrawiam,

Piotr

CreatePlease to create content