The UCS 6120 fabric interconnect has 20 fixed 10G small form-factor pluggable plus (SFP+) Ethernet ports. The base ports on the UCS 6100 series interconnect can be used as either uplink (network port) or downlink (server port). The uplink ports are connected to the external infrastructure and the downlink ports are connected to the fabric extenders in the UCS chassis. Note that the ports on the expansion modules can not be used as downlink ports.
UCS 6248UP fabric interconnect has 32 fixed 10G small form-factor pluggable plus (SFP+) ports and one expansion slot. UCS 6296UP fabric interconnect has 48 fixed 10G fixed small form-factor pluggable plus (SFP+) ports and three expansion slots.
Supported Expansion Modules
UCS 6100 series fabric interconnect support the following expansion modules:
The first module (N10-E0080) is a Fiber channel only module and has 8 ports for 1/2/4G FC connectivity.
The second module (N10-E0600) is Ethernet only module and has 6 ports for 10G Ethernet connectivity.
The third module (N10-E0440) supports both Fiber channel and Ethernet, and has 4 ports for 10G Ethernet connectivity and 4 ports for 1/2/4G FC connectivity.
The fourth module (N10-E0060) is Fibre Channel only and supports 6 1/2/4/ 8G Fibre Channel.
UCS 6200 series Fabric Interconnect support following module:
UCS E16UP expansion module using the small form factor pluggable plus (SFP+).
License requirement in UCS
The UCS 6100 series fabric interconnect comes with 8 port license included. If required, additional necessary port license can be purchased. The UCS 6120 fabric interconnect also has one free slot to insert an expansion module, if you require more ports on the fabric interconnect. All of the expansion modules come with pre-installed license and thus no license is required to be purchased in case of modules. Note that you can not transfer port activation between the expansion modules and base ports on the fabric interconnect. The 10G Ethernet ports on the fabric interconnect as well as on the expansion modules also serve for FCoE (Fiber Channel over Ethernet) connectivity. The FCoE license is also included with the fabric interconnect and thus it is not required to be purchased separately.
Hi all, I'm trying to upgrade my Tetration Cluster from version 22.214.171.124 Patch 126.96.36.199 to version 188.8.131.52 I have downloaded the 6 rpm files and requested the upgrade link. When I open the upgrade link it shows me the RPM upload page. I can ...
We have configured VRRP between two ASR9k as you can see in the picture below. One is MASTER second router is backup. We have a laptop connected to Leaf-C1. The laptop runs the ping command to VIP, then we reload Leaf-C-3 which is connected to Master. Pin...
Hey Folks, is there anybody using port-profiles in Cisco Nexus switches? Or how do you manage ports like ESXi server ports with the same vlans on your Nexus Switches? I use it and managed it by DCNM Lan Classic. Now, I updated DCNM to 11.5 and L...
Dear all,When it configures like the following, it can verify without statistics per-entry however I can not check the relationship betweenthe configured ACL and Physical interface, if the show hardware access-list vlan [vlan-id] input statistics, it show...
I should qualify and say - trying to talk. I have a small lab with a couple of servers, a couple of NAS devices, a switch a router... all the toys to make for a pleasant evening of testing. I have sub interfaces on my router and traffic is getti...